solder powder mix machine

This set is mainly used for solder bar manual casting. Pour the melted solder liquid into the mould. And after well-cooled down,
Please use the tinpot which we specially made for the pouring. Pour the liquid into the mould, according to the principle of firstly slowly to fast, then fast to slowly. The pinpot mouth should be closely to the mould to let the liquid flowing in along the mould wall. And at the same time, turn on the cooling water to cool down the mould and the tin bar. (When casting, the circulation water should turn on little by little. And after some more time, the temperaturer gets more stable, then turn on it fully.
If making the pure tin, and when the temperaturer reach to 330°C, put in some anti-oxidation solder bar. Then after the liquid become as bright as the mirror, and the temperaturer reach to 280-300°C, then the casting can be proceed on.
If making 63Sb37Pb, when the temperaturer reach to 300°C, put in some anti-oxidation solder bar. Then after the liquid become as bright as the mirror, and the temperaturer reach to 260°C, then the casting can be proceed on.
Note: If the content seal is needed, then the seal and the tiplayering are controlled synchronized by the air cylinder. During the normal use, no foreign matter are allowed between the content seal and mould board contact surface. And the content seal are adjustable according to the clients’ requirements.